![]() The two uplink ports for interconnecting the CX320s are also in load sharing mode. The two ports on Controller 0 of the MZ520 are connected to one switch module for load sharing. Port trunk allow-pass vlan 20ĬX320 (3) has similar configuration to CX320 (1), and CX320 (4) has similar configuration to CX320 (2).Īfter the configuration is complete, CX320 (1) and CX320 (2) function as one switch module, and CX320 (3) and CX320 (4) function as one switch module. Proceed with the following configuration in the stacking system: interface Eth-Trunk 1 CX320 (1) functions as the master switch module, and CX320 (2) functions as the slave switch module. The two CX320s automatically set up a stacking system. Save the configuration on CX320 (1) and CX320 (2) and then restart them. ![]() The configuration of each CX320 is as follows: The two uplink ports for interconnecting the CX320s are configured as link aggregation in LACP mode, as shown in Figure 5-20.įigure 5-20 Networking topology of MZ520 NICs connected to CX320 switch modules with ports in 802.3ad link aggregation mode The two ports connected to the same MZ520 are manually configured as link aggregation. Therefore, either CX320 (1) and CX320 (2) or CX320 (3) and CX320 (4) must be configured in stack mode. The two devices at both ends of link aggregation must be in the same stacking system. This mode requires that the port on the peer device (CX320) must be configured with link aggregation that complies with IEEE 802.3ad. Set the bonding mode to 802.3ad, that is, the link aggregation mode complying with IEEE802.3ad. The IP address of the NIC team is 192.168.20.40/24 and belongs to VLAN 20. The IP address of the NIC team is 192.168.10.30/24 and belongs to VLAN 10. ![]() The IP address of the NIC team is 192.168.20.10/24 and belongs to VLAN 20. The IP address of the NIC team is 192.168.10.10/24 and belongs to VLAN 10. The following lists the configuration on each MZ520:Ĭonfigure NIC teaming for Port 0 and Port 1 in 802.3ad mode. For details about port bonding, see NIC team configuration in Configuring Port Bonding for the MZ520.
0 Comments
Leave a Reply. |